2.
3.Build the walls out to the windows (cover the 1.5" gap) and sprayfoam
4.Attach the final remaining duct boot to the bulkhead
5.Build the step down from the landing to the basement floor
6.Finish insulating
7.Install vapour barrier
5 to go...
Friday, September 10, 2010
2 Down
1.Fasten the bottom plates of the walls to the floor
2.Finish wiring the baseboard heaters and light fixtures
3.Build the walls out to the windows (cover the 1.5" gap) and sprayfoam
4.Attach the final remaining duct boot to the bulkhead
5.Build the step down from the landing to the basement floor
6.Finish insulating
7.Install vapour barrier
5 to go...
2.
3.Build the walls out to the windows (cover the 1.5" gap) and sprayfoam
4.Attach the final remaining duct boot to the bulkhead
5.Build the step down from the landing to the basement floor
6.Finish insulating
7.Install vapour barrier
5 to go...
Subscribe to:
Post Comments (Atom)
Posts
1 comments:
Oddly, we're at the same stage in our reno. Our list is strikingly familiar - wiring, insulating, spray foaming ... No duct boots, but we will get to use duct tape on the dryer vent. Life is good.
Love, Mom
xox
Post a Comment